Amethod for simultaneous compensation of polarization drift in a fiber-optic quantum channel, and a fully fiber-optic receiver has been successfully developed, implemented, and tested using a commercial QKD system. The method is based on the exact analytical solution we derived, which gives the necessary corrective transformation for polarization. Noise and imperfections in any realistic system require iterative application of the computed corrections. In our case, polarization drift compensation was completed on average in 2-3 iterations. This is an improvement by a factor of 10-100 compared to the common methods based on hill-climbing algorithms.
Журнал: Optics Express
Идентификаторы и классификаторы
- Префикс DOI
- 10.1364/OE.538960
Для цитирования:
ШАХОВОЙ Р. А., МАЙБОРОДА В. Ф. ANALYTICAL SOLUTION TO THE PROBLEM OF POLARIZATION DRIFT COMPENSATION IN AN ALL-FIBER QKD SYSTEM
Текстовый фрагмент статьи
1. Introduction
The very first quantum key distribution (QKD) field tests using a commercial fiber-optic quantum channel (QC) employed polarization encoding of qubits. These tests immediately revealed the need for active compensation of polarization drift in a fiber-optic QC [1]. This is a long-standing problem that still requires a more efficient solution.
Propagating through a standard single-mode fiber, the states of polarization (SOPs) of photons change randomly due to residual and induced birefringence. This inevitably increases the quantum bit error rate (QBER). To ensure that the QBER is low enough to yield secret encryption key, active polarization drift compensation is required using a high-speed polarization controller (PC). This can be done in several ways.
The authors of [2–5] used a traditional approach of QBER minimization via various hillclimbing algorithms. QBER was considered as an unknown scalar function of several variables, namely the control signals of the PC. The minimization result was achieved in tens to hundreds of iterations.
Much more robust and efficient method was proposed and tested by the authors of [6,7]. Their procedure is based on mapping the estimated QBER on the Poincaré sphere. The compensation result was achieved in just a few iterations. Unfortunately, the method is not applicable to QKD systems with all-fiber optic receivers, since polarization drift occurs not only in the fiber-optic QC but also in the fiber-optic receiver itself. This makes the task of efficient drift compensation more complicated.
The authors of [8] took into account both of these sources of polarization drift. They proposed and tested a polarization compensation method based on determining the Mueller parameters for optical links and then obtaining the optimal PC parameters using a gradient descent algorithm.
For the problem of simultaneous polarization drift compensation in QC and all-fiber Bob, we have derived an analytical solution that is simpler and more efficient than the method described in [8].
In Section 2, we formulate the main problem and a simplified related problem that helped us to find a general solution. In Section 3, the simplified problem is studied by computer simulation and its analytical solution is found. In Section 4, this particular analytical solution is generalized and applied to the main problem. Our experimental data are discussed in Section 5. The main results of this report are summarized in Section 6. More formulas related to the analytical solutions can be found in Appendices A and B. More details on our experiments can be found in Appendix C.
Будьте первым, кто начнет обсуждение
Если у вас возникли вопросы или появились предложения по содержанию
статьи, пожалуйста, направляйте их в рамках данной темы.